AMPTEK PX4 DRIVER DOWNLOAD

Many functions are also accessed by toolbar buttons. Common controls also set by shortcuts. Mark an ROI region of interest around each peak. Move the dialog box such that both peaks are visible and then click the cursor into the first peak. See the quick start guide of the appropriate product for more information. Dynamically linked software does not require a re-compile, only copying the new dll into your installation.

Uploader:	Akinotaxe
Date Added:	27 October 2012
File Size:	33.6 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	9969
Price:	Free* [*Free Regsitration Required]

Amtpek controls also set by shortcuts. In the Units box type in the energy units, e. There are different options depending on the product in use. To adjust the energy range it is always the gain of the system that must be changed. Diagnostic data will be dumped into the box; this includes a hex dump of the configuration memory.

The peak should be highlighted and the Peak Information section on the right-hand information panel should be filled in.

DPPMCA Display & Acquisition Software

Typically includes acquisition presets, gain, peaking time, detector HV, detector temperature, number of channels, risetime discrimination parameters, and many more. Then enter the energy of that peak into the Value box, e. This is done maptek adjusting the gain of the amplifier. Instructions for saving and emailing a. Many functions are also accessed by toolbar buttons.

Software computes centroids, FWHM, net area, and other quantities. This will amptfk the noise of the system. Put the source back and check if the spectrum appears. All functions can be accessed via the command menus.

DP4 and PX4 Digital Pulse Processor Software – Amptek – X-Ray Detectors and Electronics

Features Full control of all hardware features. Please read the Quick Start Guide for your product. Go to the Software Downloads page. This package includes information on how to control the digital processor using the the USB driver calls and provides complete information on the communication protocols USB and RS Products for your imagination. Controls are grouped by tabs. See the quick start guide of the appropriate product for more information.

This will enter the center position of the peak into the Channel box. The Amptej is a FW6 device. A lower gain corresponds to a higher energy range, and a higher gain to a lower energy range. The DP4 is a legacy FW4 device. Sometimes no spectrum or a distorted spectrum will appear if the fast and slow thresholds are not set properly.

The software calibration is only in software. It is a socketed part so no soldering is required. If you will use the hardware only on bit operating systems you do not need to perform the upgrade.

If the auto tune fails, or if the counts exceed the input counts, perform the manual adjustment in the next step The Fast and Slow Thresholds can be adjusted manually. The scale should now be in energy. It contains an example in VB of how to directly control the devices using the most low-level calls available.

This should only be used by experts who need to adapt these devices to non-windows platforms. For example, an iron Fe peak at 6.